-
hello im not sure if you can help but im only amateur at best with coding. attached i will show the coding i used
Problem (if i run the blink sketch with the relays on the arduino they work) did t…
-
Currently when you install the LCD drivers they disable the HDMI port. It's not clear how to un-do that. Technical research on the feasibility and approaches would be really great.
-
Hi, i need to use this board
https://www.olimex.com/Products/IoT/ESP32-C6/ESP32-C6-EVB/open-source-hardware
but i can't find a valid platformio.ini file
Thanks
-
38M-49SMD-SR -> 8M-49SMD-SR
-
Not an issue, just somewhere to record some information.
A bunch of photos of the internals of the 3A smart home switch. (Purchased from ebay at https://www.ebay.com.au/itm/Smart-WiFi-Desk-Lamp-Light…
-
### The problem
Detected that ESP32 devices are not properly announcing mDNS .local domain when using multicast-relay solution. Before moving to this mDNS solution, I was using Avahi service that was…
-
### What happened?
I have a long strip of FW1906 leds (RGBCCT) and a relay to turn off the power supply when not in use (using the built-in relay feature of WLED). WLED controller is always powered.
…
-
Since I cannot find a way to ask questions about the PCB files, Ill just post it here even though it is not an issue. Is it worth to have the PCB professionally manufactured at this point? I don't hav…
-
### Board
ESP32 wroom-32e
### Device Description
can not make canbus work, i used a SN65HVD230 and twai library with esp32 board updated to 3.0.4 (not work on 2.0.11 too)
### Hardware Configuratio…
-
In v1.1.0 we need to increase the height of the lid (~2-3mm) as it collides with the relays on the double relay board, causes some flexing.