-
i build the 1st 3d printer and the extruder does not move
can you help me
what is the reason
#define EXT0_X_OFFSET 0
#define EXT0_Y_OFFSET 0
#define EXT0_Z_OFFSET 0
#define EXT0_STEPS_PER_MM…
-
When I open repetier in Arduino 1.8.8 i get the following error at the console window.
"Communication.cpp" contains unrecognised characters. If this code was created with an older version of Arduin…
-
When I press "Stop" when heated, the printing is not cancelled. This occurs both in Repetier host, and from the screen.
-
When installing the latest .091 repetier/rostockmax firmware onto a V1 Rostock Max, and home all from mattercontrol OR from repetier-host (both for mac), the Y tower will literally drop all the way do…
-
Hi,
I would like to install the Repetier-Firmware. I had a quick look into the Configuration.h. The settings are quite different compared to Marlin.
Before I start searching and reading all the docs,…
-
If I load / flash other 32 bit versions of Marlin like Repetier or Wurstnase - Marlin4Due there is no problem, but with MK4due windows no longer recognises the native port, the programming port is fin…
-
Using Cura, if there are more than one extruder, Repetier will only turn on the heater for the default extruder. I don't know if this is a Cura issue or Repetier issue.
-
Hi,
I'm using Repetier-Host to connect with the printer using WiFi.
I always get WIFI: -78 (the signal strength) printed on the log windows. I think that it becomes from the esp and the serial conne…
-
For some reason, it is does not show up Slic3r frontend only in Repetier Host using Slic3r as slicer.
-
I wanted to change the eeprom settings in Repetier-Host through Wifi connection, but it is not possible, the window is empty. The M503 command has only OK respose.
![Repetier-Host](https://user-ima…