-
Hi,
It's very common in new sensors send directly one downlink frame in order to configure the sensors (like https://www.nasys.no/ sensors)
This is necessery only one time, and I need to creat…
jot4p updated
5 years ago
-
# ARTIQ Feature Request
## Problem this request addresses
Phaser ([hardware](https://github.com/sinara-hw/phaser) [gateware](https://github.com/quartiq/phaser)) is a Sinara SAWG (smart AWG) …
-
create mode listen to read all kind of remote controls.
-
Can someone point me to a detailed datasheet documenting the features of the ChameleonMini RevG RF hardware? The only ones I can find online are single pages. I remember that one of the really innovat…
-
Hello!!!
Ive detected some time the controlPanel unit make reset..... At the start show the initial title reset and show again the title..... and sometimes when I change from IN to MM,,, sometimes…
-
Using me Fatshark HDO2 with the Foxeer Wildfire analog module, a luminier omni antenna and a sniper patch antenna, I got very good results and my analog image is stable and clear.
However when usin…
-
- [X] I have updated my IDF branch (master or release) to the latest version and checked that the issue is present there.
- [X] I have searched the issue tracker for a similar issue and not found…
-
I have a project in which I have a few outputs: IR LEDs and a 3.5mm wire going directly into the IR receiver of another device.
Controlling devices over the IR LEDs works fine, but to control the d…
-
Pavel, thank you very much for all of this helpful information. I am thinking about a project similar to your PulsedNMR, but I am not sure if the Red-Pitaya hardware is suitable or not. All of my pre…
-
I am proposing the following decoding for a swann RF 433 doorbell.
```
decoder {
name = Swann-Doorbell,
modulation = OOK_PWM,
short = 200,
long …