-
**Describe the bug**
The wifi device doesn't appear with `ip a` command.
Failed to run INIT ucode: -110
`dmesg |grep iwlwifi` gives:
```
[ 4.150315] iwlwifi 0000:00:0b.0: can't derive rout…
-
In PiScope I get about 12 sbus signals in a second, but for some reason, this library lags a lot, like 1-2 seconds before it realizes the sbus signal change. Like playing an FPS game with 2000ms pings…
-
Hi,
I'm not sure how to set up the configuration of OxS RP2040 and FlySky FS-IA6B.
I already made it work with telemetry configured on the left "SENS" port of the Rx connected to pin 0 of RP2040.
…
-
## Current Behavior
Failsafe flag on sbus always low however "packet lost" flag works fine
## Steps to Reproduce
1. Flash "master" with PR#2094
2. Choose output protocol as "Sbus"
…
-
### Describe the bug
The FC receives data from the remote control (FS-i6S) but the remote control does not receive any telemetry from the FC (only internal receiver telemetry: signal strength & vol…
-
When I was flying, I noticed that a mode I had assigned to Channel 13 got triggered when I had low signal. Should this this be expected? Not 100% sure on the meaning of '4 channels with three steps …
-
## Current Behavior
I am in the process of upgrading a Matek H743-WING V2 Flight Controller + XF Nano Diversity setup from INAV 3.0 to INAV 5.1 and am running into an issue. When I arm and disarm th…
-
## Current Behavior
When powering on the AIO (GEP-12A-F4) I only get a solid yellow light on the EP2. I can't interact with the EP2 (no connection or Wi-Fi). After many power cycles it sometimes ge…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Other (Please specify below)
### Current Behavi…
-
Hi i really love your project ! The ronin SC is very affordable.
Do you know if i can set an absolute axis angle using SBUS? Or are all controlsignals relative signals?
Thanks alot!