-
No matter what printer is selected it prints defaults from the J1 to the gcode when exported. Not sure if it's a real issue, but I imagine that if it thinks it's the wrong printer, it could send some …
-
pls make working for J1 like cura J1 plugin
https://github.com/Snapmaker/SnapmakerJ1CuraPlugin
thanks
-
Asking for a possibility to adjust/calibrate extrusion steps of both extruders. A guided/semi-automated calibration would be nice.
Reason: ensuring no over/under extrusion could be the root cause of …
-
Would love to use your tool in Prusaslicer.
Best solution would still be a fully working octoprint connection to J1, but I don't expect that to happen anytime soon 🤐☹️
-
### Description of the bug
My printer doesnt recognized the thumbnail. So I looked into the gcode.
There is see this:
```
; thumbnail begin 200x200 20088
; iVBORw0KGgoAAAANSUhEUgAAAMgAAADICAYAAAC…
-
# 🐞 bug report
### Affected Version(s)
Luban v4.7.1
### Is this a regression? (optional)
Unknown
### To Reproduce
Steps to reproduce the behavior:
1. On a fresh clone of the Snapmaker…
-
You have several retraction settings which are incorrect. Look at any of the Polymaker materials.
The retraction distance is 6mm which is appropriate for a Bowden drive system, but not a direct d…
-
Hey, thank you very much for this plugin. I just assembled my Artisan yesterday and I'm looking at the different tooling available in the community. I got a few recommendations for Cura and wanted to …
-
With Snapmaker 2, Firmware V1.10.1_20200822, i run regularly into the situation, where a print job is started, but temperatures are set to 0 after a few seconds. (G code is generated by either Luban v…
-
After downloading the latest plugin 0.4.0 release, and Cura version 5.2.1, Cura is unable to connect to printer and gives a "could not connect to device" description after trying to connect via enteri…