-
I am using a slightly midified compliance-sketch.
Main changes are UART.Interface to set the LoRaWAN registration parameters.
I temporarely published the sketch on https://bitbucket.org/thl-mot/lmi…
-
hi all,
hereinafter a compiler warning while I compile EasyLoraGateway , is it ok ? how to fix and clean the warning.
C:\Users\Myfamily\Documents\Arduino\libraries\HttpFOTA\src\HttpFOTA.cpp: I…
-
Hello, I'm new to this.
With Arduino UNO, there are TX and RX pins for me to establish UART connection.
Which pins can I use to for TX and RX? Thanks.
-
Hi,
is it possible to add support for an Inkbird ITH-20R for esp32 with cc1101 i am not sure how to add additional decoders. a link for it working with rlt_433 is , https://github.com/ehagan/rtl_4…
-
I would like to know how to configure the MISO, MOSI, SCK and SS pins for SPI in the case when I'm using the custom board?
From hal.cpp I can see that the library uses default pins:
```
static …
-
HI, I'm trying to compile the ESP-1ch-Gateway with PlatformIO, but I get these errors :
C:/Users/Admin/Documents/PlatformIO/Projects/ESP-1ch-Gateway-master/src/_txRx.ino:309:44: error: call of ove…
tk5ep updated
10 months ago
-
Hello there,
I am currently using a TTGO LoRa 2.16 in order to connect to the The Things Network. I replaced all the fields on the example sketch (ttn-otaa) from my TTN console. It has already been…
-
I was attempting to flash my lora32 board, which went successfully, but when I went to my phone to connect to the board over a Bluetooth serial terminal the board was nowhere to be found (I did enable…
-
Hey,
Im trying to figure out how and playing around with the waveshare module in combination with the raspberry pi pico, however it seems ive ran into an issue trying to run the sample code:
```
…
-
I'm using ESP-IDF 5.2 with a TTGO LORA32 board connected to a ublox ZED-F9P via I2C. I call the following init function at the start of `app_main` to initialise the GNSS module and then proceed to si…