-
CleanFlight 1.14.0, released yesterday enabled Sonar support for the SP Racing F3 EVO. Please consider adding support in iNav. Please see https://github.com/cleanflight/cleanflight/commit/6b03f97c5224…
-
Currently only 2.0.0 and 1.2.3 are available for download.
CF 1.4.2 needs configurator 1.2.4 - this version is completely missing in github at present ....
-
This is a CC3D Atom Evo. Backed up the configuration, flashed 3.1.6, restore configuration.
Yaw shows up as aux 1 and my flight mode switch shows as aux 2. Channels 1-4 show no activity on the r…
-
Since I updated to 2.2.0N369 with Spanish menus, after some normal operation, Taranis Q X7 started to show a very odd behavior:
- Voices seem to be played very slow so it is impossible to understand …
-
Hey out there,
I wanted to install my GPS Ublox 7m mini, but when I enabled the Uart Port and the GPS in the config tab I wanted to change to the Ublox protocol, but when I save and restart it just …
-
I switched on sonar in the configuration tab and saved it to the naze32(Firmware version 2.0.2) but it never seemed to be active. After some research it seems to be disabled because it is commented ou…
Fl0h0 updated
7 years ago
-
I am pretty sure this is a know issue [https://github.com/betaflight/betaflight/issues/2162](url) but problem with the Femto is its an AIO with only 4 dedicated motor +/- and signal pads so remapping …
-
I installed iNav on naze rev5 on fixed wing and when i select angle mode servo very slow correction direction model and somehow all commands have a delay. Servos are analog. Who knows what the prob…
-
Hello,
I mounted the new Afro , replaced an engine that no longer worked, recalibrated the esc but the problem remains that two motors are out of calibration when using the remote control .
I attach…
-
Hi,
I read many info online about flashing the latest CleanFlight at CC3D (which comes by default with librepilot/openpilot firmware). Some people said I should use GCS (from LibrePilot) to flash t…