-
[devices] :
Jumper T16
edgeTX 2.8.0
Betaflight firmware : 4.3.0
[Betaflight setup] :
Suck on "Wait for API version" when using "Betaflight setup"
![IMG_6571](https://user-images.githubuse…
-
When I replaced the previous broken F4V3 with a new F411 wing flight controller, I found that the TBS receiver Telemetry can only receive 10 basic sensor data. After studying issues on github(#6931 #5…
-
## Current Behavior
When activating the GEPRC M1025-DQ GPS, DPS310 barometer on my SpeedyBee F7 V3 stack with iNav 7.1.1, a red icon appears next to the barometer status and the ESC continu…
-
Hello, I just created a new Laravel 5 a minute ago
And I notice the $kernel->terminate at the end of the index.php file is not being called.
Therefore the Session is not being saved() and CRSF secur…
-
# Description
MWP is not showing any Radar tracked crafts when a TTGO LoRa V1.0 Module is connected to the GCS Hardware. Neither in Primary connect mode nor in Telemetry Tracking mode.
# Used Har…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Transmitter firmware
### Current Behavior
when the mod…
-
### Describe the bug
BF 4.4.x bug where iBus and some other protocols don't show the bars on the chart in the Receiver tab of the Betaflight configurator.
### To Reproduce
Using a Mateksys F405 STD…
-
### Describe the bug
A few seconds after power on FC freeze. Before freeze, it works normally, I can see animated 3D model in Setup tab to react. After freeze it does not react to anything, 3D mode…
-
To enable CRSF out on the E5 grove, I add the line '#define DEVICE_HAS_OUT' to the HAL (wire is soldered to PC1), but this seems to output CRSF at 100K baud which ArduPilot doesn't recognize. When I …
-
Hello Mstrens,
I continued with the tests this morning,
I discovered the following:
Ver.2.8.33 FBUS or S.PORT with SBUS Protocol,
Sensor lost messages set to 5 second delay.
LOG=255 everything el…