-
I'm getting it to upload to my 1MB ESP-01, but my ESP-01 won't create a network... Any solutions? The SPI speed is 40MHz and the SPI mode is QIO. Should it say "is stub and send flash finish" when it …
-
### Describe the bug
The controller does not have native firmware 4.5.0 AIRB/OMNIBUSF4SD-ICM(STM32F405) Gyro ICM-42688-P
### To Reproduce
There is no such firmware in the cloud. How to flash such a…
-
I have worked with WS2812B on ESP32.
Implementation I have seen make use of the RMT module on ESP32.
When controlling strip with many pixel, I have seen glitches. Perhaps similar with #139 or https:…
-
Is it easy to add the can module after spi in armbians?
-
The `onTransmit` has no information about if it's the same transfer (chip select pin keep low). For my case, I need to simulate a SPI slave which has different behavior for different transfer length. …
-
Hello, I'm looking for a way to connect rf24l01 with raspberry, but it seems gobot didn't support?
-
This error is found on the STM32G071 but is likely on other devices too.
Ref AN4286 (rev 12) - Section 2, page 8, last paragraph:
"When the slave must transmit data, the master sends its clock, s…
-
I'm trying to understand FPGA-shells so I can add a PCIe to my SoC in Chipyard, but I was also thinking of adding SPI flash. While digging through VCU118NewShell.scala I saw that `//SPI Flash not func…
-
Is there interest in supporting decoding of DAB SPI?
This would support:
* Reception of Station Logos
* Reception of Programme Schedules
There isn't an open source DAB EPG decoder, so this mig…
-
As passthrough logic filters incoming commands if they are not in the command information entries, filtering CSR usage is low. We could introduce the `filter` field in the CMD_INFO structure if a comm…