-
see: https://travis-ci.org/unitware/cleanflight/builds/210546524
using a custom travis.yml that only specifies a test goal and a few targets
```
env:
# - PUBLISHMETA=True
# - PUBLISHDOCS=True…
-
After activating servo-tilt in the configuration tab, motor connectors does not switch from 1-4 to 3-6.
I tried to connect the servo to port 5 or 6. Doesn't work.
I got the same problem with Betafli…
-
I have a NMEA GPS connected to UART2 at 9600 on a Flip32 board. Current Cleanflight release picks GPS up correctly and shows pos + satellites. Same settings on iNav show no GPS data on the GPS tab.
…
-
If the Openlogger is connected to uart2 on a Naze with both TX and RX it becomes possible to dump a file to serial. With a small change in cleanflight it should be possible to redirect this dump to th…
-
Ex.Bus (Jeti) support för cleanflight?
Any code wizard that can make it happen? :D pretty please with suger on top.
Here is the documentation for Ex.bus protocol which maybe makes it easier to deter…
-
Some people have been hacking some of the toy quads. Most of these seem to have 16K ROMs, but a few have 32K ROMs. Some of these hacks are based on forks of Bradwii, for example see [Bradwii for JXD J…
-
stick command for gyro calibration does not work anymore in 1.12 on my naze32 rev5.how can I manually calib gyro before start ?
-
The Serial RX is not working for iBus in the actual version of CleanFlight. This issue has been reported too in BetaFlight: https://github.com/betaflight/betaflight/issues/2637
I've tested it with a …
-
Can you guys please put back the master file for 1.2.4gui
-
I want to use the library to send commands to my naze32, but typing `feature SERIALRX` in the CLI gives invalid name error. Is this due to the version of cleanflight? If so do you know what the new c…