-
* rpi-deep-pantilt version: 1.0.1
* Python version: 3.7.3
* TensorFlow version: 2.0.0
* edgetpu version: 2.15.0
* tflite-runtime version: 2.1.0.post1
* Operating System: Raspbian 10 (buster)
#…
-
I was running hassio on a pie and the wyze sensors would just stop responding after a day or sometimes 3 days. A reboot would fix the problem. Recently I have switched to running home assistant in a…
-
Cannot get the TFT35 touchscreen to work with octoprint using a MKS GEN L?
When removing the touchscreen, octoprint works normally.
How to fix this problem
-
Hi Kris,
Using the BNO055 in my Attitude indicator instrument project, based on an Arduino Mega.
The Roll and Pitch info is quite perfect on the test bench.
BUT when installed the instrument in my…
-
Hi Kris,
Amazing work porting the MARG into a nice arduino sketch!
I have got it to work with the https://www.sparkfun.com/products/11486, but the yaw values don't range 360 degrees as I rotate the …
-
I just came across [AngelNav](https://www.angelnav.co.uk/) by Tom Cunliffe. It features some nice tools for classical chart work like you would do it on paper charts.
- draw a bearing line
- draw …
-
If you use a touch screen display, you would no longer need the strain gauge. You would also open up a lot of new capabilities such as gesture controls.
-
I went down a rabbit hole and want to pin this idea in case someone wants to take it up later: optimal fuzzy matches between the gsheet and CCV databases (or potentially any other database formats we …
-
Dear Pawel,
I have just installed you OGN-tracker to work with my Stratux on a T-BEAM and that works fine from firmware.binary coming from new Stratux eu022.
I have then compiled the firmware with …
-
----
### Issue details
I'm trying to send commands via mavros to my pixhawk flight controller to control the drone. For now I'm testing with 1 motor.
Mavros is connected to pixhawk and I'm …