-
Hub12 is very similar to Hub75, but the Output-enable has positive level (I think), and of course we can control many more panels with the outputs, as we only need Red or Red/Green and the free GPIO p…
-
Hi,
I cannot install any os from noobs 1.3.12 on some sdcards !
The install sceen is stuck on "Clearing existing EBR" and then fails.
My sdcard is a noname 8gb.
dmesg specify the following : (sorry…
-
With RPi often in headless environments could there but a cut down version that is smaller that start_cd.elf ? This would reduce boot time.
dp111 updated
5 years ago
-
For the moment, we stick to 0.10.7 so everything is ok but we had a look at what is going on in the master, and I must say I'm not too fond of the recent changes made to ola_recoder, feature-wise and …
-
I'm running part two of the SAW pipeline using manual registration. The first part goes through fine, but when I run the second part I receive the following output and it fails.
```
[WARN 20240219-1…
-
![DSC03121](https://github.com/geerlingguy/sbc-reviews/assets/481677/c39414ee-bea6-482b-bc29-e271f510f7d1)
> **NOTE**: The board used for this testing was a pre-release revision. The final producti…
-
Hi!
I would like to use the Papirus screen on a Tinker Board. Could be possible?
I´m pretty new at linux and python, so could you do a few hints to work on?
Thanks!
-
Hi, is there any pin that I can use for third thermistor sensor for heated chamber?
I tried Z stop and PS-on. No luck.
-
When using http://github.com/benhylau/mesh-router-builder to build the mesh-workshop profile the RPI 3B+ will no longer boots and complains about EOF on the ram disk. However using the same builder wi…
-
I build an image for Arch ARM (`custom-pi-recent.img`, what's in a name).
I started `lukechilds/dockerpi:vm pi2` with the command below.
I was then able to update the container/img file with `pacm…