-
[Configuration.zip](https://github.com/MarlinFirmware/Marlin/files/4117195/Configuration.zip)
VS Code terminal output
```
In file included from Marlin\src\module/stepper.h:47:0,
…
-
How can I Install a BL Touch and a Filament sensor?
And on which pin do I have to put in the Filamentsensor?
-
Bug Description
When using linear advance on my bowden system, no matter what value, even between 0 and 5, there is a big drop of plastic at the point where the speed changes, even tho the 3 segmen…
-
I understand this is not your issue at all but I thought you might understand this a little more than me.
https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/issues/43
This is the issue I ma…
-
The noise is much higher than the stock, perhaps reducing speed would be better.
![Screenshot (9)](https://user-images.githubusercontent.com/24445137/67245531-82caad00-f45c-11e9-9d51-737bf8890c24.png…
-
I have configured the SKR mini E3 v1.2 to use the BL touch. The FW works fine and probe seem to function correctly. I setup my Z offset correctly. When I go to print however the nozzle is too far from…
-
currently, I am getting _no printer attached_ messages
I am plugged into the TFT slot on the mainboard and the rs232 slot on the screen.
-
### Description
I'm trying to enable LIN_ADVANCE on bugfix-2.0.x branch on my CR-10s + Cohesion 3d remix board (smoothieboard variant).
As soon as LIN_ADVANCE is enabled extruder starts rattli…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
Not really a BUG, but a possible improvement to the limited storage of the RCT chip used on the SKR mini E3/DIP. This is posted on Reddit, I am not the author, but I have tried the proposed fix, and…