-
I am working on a seriuslypro evo3 and i uploaded my own firmware. Then i wanted to re upload the letest version of CF, so i jumped the boot pin, connected over UART1 with a FTDI chip (DFU is not seen…
-
### TODO
1. Create release notes
2. Wait for bug reports and make a list of them here.
### Release Candidate bug reports
1. Issue https://github.com/cleanflight/cleanflight-configurator/issues/383: PI…
-
# A - Description
-- Softserial and FrSky telemetry does'nt work anymore on SPracingF3 Cf2.0.3
# B - Steps To Repeat
-- Turn on softserial, connect telemetry pin to soft serial port.
The t…
-
After hours of trying different combinations of OpenTX firmware versions and iNav versions I am unable to show or log GPS Coordinates via SmartPort telemetry for my location using a Taranis X9D+. All …
-
I don't know if this is a "problem" of Cleanfligth storing incorrect data in the BlackBox, or from the BlackBox log viewer.
To tune the PID I use some graphs, I like to have in one of them:
- The RC…
-
I have flashed the CF v.1.10 to my CC3D Atom but, i cant connect it with CF configurator 1.2.0.
I have my blue led flashing slowly on my board! please help me to solve this.
-
I have an enclosed waterproof quad and I would like to keep track of temp to make stuff isn't getting too hot.
Currently cleanflight is sending a mode flag over smart telemetry for temp1
https://gi…
-
**I am not sure where this issue originates, I'm not an expert, but I cannot track down the cause.**
I apologize for all of the formatting and text, I tried to be as concise as I could.
**SETUP:**
…
-
Using current build on a good old NAZE with IBUS the stick inputs stuck at 1500.
Switches and VRs are still working.
Problem was introduced in BF build 1168. see https://github.com/betaflight/betafl…
-
Using current build or release 3.1.7 on a good old NAZE with IBUS the stick inputs stuck at 1500.
Switches and VRs are still working.
Problem was introduced in build 1168.
Another problem with thes…