-
I am using the a drofly Flightcontroll with a Mega 32u4. Could somebody help me to get the HoTT function running on my system? I am using the Graupner MX12 and would love to see the HoTT function.
-
```
What steps will reproduce the problem?
1.Install release V2.9 r300
2.Set Throttle Rate PID to P=0.35, I=0,D=0.02,IMAX=8.0
Set Altitude Hold PID to P=0.4, I=0.01, IMAX=3.0
3.Fly the quadcopter to a…
-
### Please confirm these before moving forward
- [X] I have searched for my issue and not found a work-in-progress/duplicate/resolved issue.
- [X] I have not been informed if the issue is resolved in…
-
I have been testing the wristband with the accelerometer permanently asleep and skipped with button press.
The results are very encouraging and makes the wristband much more practical for me.
Th…
-
Hard resetting via RTS pin...
Executing action: monitor
Serial port COM838
Connecting...
Detecting chip type... ESP32-S3
Running idf_monitor in directory d:\esp32\esp-drone
Executing "F:\Espress…
-
```
What steps will reproduce the problem?
1.Install release V2.9 r300
2.Set Throttle Rate PID to P=0.35, I=0,D=0.02,IMAX=8.0
Set Altitude Hold PID to P=0.4, I=0.01, IMAX=3.0
3.Fly the quadcopter to a…
-
Hello,
whatever I am doing I always get the report that there is a magnetic anomaly detected.
I am using a Teensy 3.6 and added the "i2_t3" library and optimized the USFS library to work with it.
…
-
Hi, I couldn't connect esp32 to the modified cfclient but was able to get gyro values using pythonlib. How to enable altitude hold mode in the drone without cfclient? I'm using esp32s Wroom 32
-
Hey Kris, i wanted to get readings from two MPUs but since there is only one mag address the solutions i could find was using a multiplexer. Is there any other way? Should i consider using SPI interfa…
-
When trying build for the pi, the build fails with this output:
`make ARCH=arm CROSS_COMPILE= -C /lib/modules/3.13.0-24-generic/build M=/home`
`/path/to/rtl8812au modules`
`make[1]: Entering direc…