-
Hi,
I'm developing a TX RX radio based on NRF24L01+ where telemetry data will be sent to OpenTX remote (Flysky TH-9X)
So far am able to get telemetry data displayed on screen using MAVLink (ardupilotm…
-
Crazybee flight controller with spi-rx. D16 mode causes twitching while flying. Dshot600 mode causes failsafe while in d16 mode.
D8 mode works fine in multishot but in dshot600 it arms then immedia…
-
Hey guys so I just got my Eachine Wizard x220 with the SPRacing F3 Flight controller and I had an issue. The quad binds with my FS I6 but in the receiver tab of my beta flight there is no stick moveme…
-
Does it have support for Flysky X6B I have tried about everything but nothing works.
-
NOT an issue!
I found this via http://forum.arduino.cc/index.php?topic=515259 I haven't used it yet but I just can't stop me from making this comment. It is so overwhelming to see all your work. Yo…
-
I'm thinking about something to enhance Fixed Wing experience when in PASSTHROUGH mode.
Basically what pilots do, if they can, is to add some additional expo on the radio when they switch to PASST…
-
I'd would really like a way to adjust the read voltage from a FS-CVT01 as they are notorious for being off by .2V+
Thanks!
-
Hi,
I really dont need the 10ch of this firmware -> https://github.com/benb0jangles/FlySky-i6-Mod-/tree/master/10ch%20Timer%20Mod%20i6%20Updater/10ch_Timer_MOD_i6_Programmer_V1_4
I just need the…
-
Noticed that 10.2 now has 6 rate profiles as opposed to 3. I can't seem to figure out how to select the last 3 rate profiles.
Thanks
-
Hi, I am not sure the issue publish already or not ,but still wish who can solve this problem.
My case:
I have 2 board of Omnibus F4 v2 pro and Omnibus F4 v3 , I found out a big problem is that
…