-
I'm putting together a system with a handful of Beckhoff modules that I'm going to use for testing. The goal is to have code changes verified against at least *some* of the modules that we support. …
-
I'm trying my first steps with LinuxCNC and EtherCAT. Following the example of [this forum thread](https://forum.linuxcnc.org/24-hal-components/42291-basic-ethercat-configuration) I started with:
`…
-
The website can be really hard to read. It is clearly not
ADA compliant.
Take this page for example:
https://www.linuxcnc.org/documents/
The text at the bottom is small, and light gray font…
-
I have searched a lot over the internet but could not figure out the G-code syntax for touch off and saving that tool height in non-volatile memory just like work offsets. What are all queries related…
-
Hello, it seems there’s a typo in the names_misc_errors array definitions inside of motion.c.
It appears it’s using the count of array elements of names_dout instead of names_misc_errors, which …
-
The actual support matrix is kind of messy right now. It doesn't help that Beckhoff produces a huge number of very similar devices; ELxxxx and EPxxxx devices are frequently completely compatible, but…
-
Right now, adding new drivers involves a few steps:
- Writing the driver itself, in lcec_xxxx.[ch]
- Adding the new driver to lcec_conf.[ch]
- Adding the new driver to lcec_main.c
- Adding the new…
-
Hello,
I made next configuration for PNCconf.
I made 7i96_7i74d.bin
https://forum.linuxcnc.org/27-driver-boards/47764-ask-7i96-7i74d-bin
In private_data.py I added:
` ['7i96-Internal Data'…
zz912 updated
8 months ago
-
Hello,
Maybe someone can help me
I try fresh install linuxcnc 2.9.1
I use nvem v2 with rt1052 with firmware rt1052 V3.1.0
I add components remora-eth-3.0.c and remora-nv.c, i use config remora-…
Nvems updated
9 months ago
-
Hi all,
I'm currently working on ramps for acceleration temporal and before I forget this I write it down.
I found an issue in timer_set(). The part `(current_counter - match_last_counter)` can be n…