-
Hello.
I'm not able to connect BLHelisuite to my ESC using 1wire.
I can do it if my FC is running cleanflight. I have flashed my ESC with the last firmware and change the bootloader to the last blhe…
Viald updated
7 years ago
-
Hi!
I'm working on compiling Cleanflight to run on PC.
I've noticed that on first loop the "cycleTime" variable is very small (12-18, compared to expected 3500).
Is this normal?
Almost always it lea…
-
It should be possible to select "popular" receivers, and have the configurator set whatever parameters it needs to, so that there is less command line / apparent not saving due to feature conflicts.
M…
-
AFAIK, when baudrate decreases, the range increases. So It would be good to permit lower baudrates to LTM protocol (until 1200bps perhaps).May be for a audio-over-video downlink or other telemetry sys…
sppnk updated
7 years ago
-
To recreate:
1. Flash CC3D with cleanflight w/ the OP bootloader.
2. Open Cleanflight configurator
3. Go to the CLI tab, type "save" and press enter
4. At this point, you should no longer be able …
akcom updated
7 years ago
-
Hello,
I am the happy owner of a F4EVO.
I can not operate the magnetometer, in fact the icon remains desperately gray.
The baro is functional, is there a way to unlock the magnetometer?
Thanks i…
-
SMALL_ANGLE condition is checked as
- https://github.com/cleanflight/cleanflight/blob/master/src/main/flight/imu.c#L92
```
smallAngle = lrintf(acc_1G * cosf(degreesToRadians(imuRuntimeConfig->small_a…
-
I have activated Sonar, without Softserial, on version 2.0.1. Used port vor Sonar (io1 port 5&6)
No respons, measured with logic 4. Also no frequenty on trigger or echo.
do i have to use the special…
-
alignSensors() is repeatedly applied if no new value is returned from `mag.read(magADC);`, possibly rotating last value indefinitely.
https://github.com/cleanflight/cleanflight/blob/master/src/main/s…
-
I have load cleanflgight 1.9 to a CC3D Atom board an to a flip32 10Dof with airplane configuration.
on cleanflight GUI the radio input is correct (maps correctly radio stick movements) and outputs ar…