-
Noticed that 10.2 now has 6 rate profiles as opposed to 3. I can't seem to figure out how to select the last 3 rate profiles.
Thanks
-
How to reset radio to factory default parameter on the radio? firmware: flysky with atmega128
-
I have connected my SBUS Turnigy IA6C like is shown on the MatekSys website: http://www.mateksys.com/?portfolio=f405-osd
but when I connect I cannot arm or do anything involving the transmitter. When…
-
I apologize if this issue would be better addressed in a different forum, but I trust the expertise of those here. I've tried many different options but I'm getting a pendulum type swing the slowly co…
-
hi, i decided to try this. after i found the hoverboard.bin firmware ready for the st-link. ([https://github.com/NiklasFauth/Hoverboard-Board-Hack/tree/master/build/hoverboard.bin](https://github.com/…
-
Receiver mapping appears to be an issue with Cleanflight/SP Racing F3/Flysky ia6 when connected via PWM.
Channels are mapped correctly in Cleanflight and are connected to the appropriate pins on th…
-
hello, my transmitter is flysky th-9x, i have the Frsky mod,reroute the pin2 to pin41 and pin3 to pin42, pin2 and pin3 used for the telemetry. then change the chip to atmega128.
then, i flash the er…
-
# A - Description
I'm not able to connect through to BLHeli Suite via CleanFlight. The error message says My current cleanflight configurator is not supported via BLHeli Suite
# B - Steps To Rep…
-
Do you have some infos about the maximum performance in (watt) the diy transmitter module has? It's important for using it in the EU.
https://www.banggood.com/2_4G-CC2500...p-1048377.html
-
Hi,
Have you had a look at whether it is possible to port this to the new Turnigy Evolution?
https://hobbyking.com/en_us/fpv-racer-radio-mode-2-white.html
https://www.youtube.com/watch?v=ZMHVIhZzS…