-
Hi,
what do I have to change to reverse your code from the LOW pin model to a HIGH pin Model.
int current_brightness = 100; // LED STRIP OFF (100), LED STRIP ON (0) My dimmer module is driven L…
-
I realize this is an odd thing to complain about but a QucsStudio file converted to Qucs and opens in Qucs crashes Qucs-S.
I figured the file crash issue could be important. Normally Qucs would flag …
-
The shopbot has contactors that disable (cut) power to stepper motor drivers and VFD when alarm or emergency stop signal happens. These contactors have an auxillary signal (24V) that is used to detect…
-
Hi for some reason fan2 is suddenly at 100% duty cycle all the time, even after rewrite or reset. So I was wondering if there are schematics available for this board in order to find the issue.
I ca…
-
Behavior:
sometimes it feels the robot is not mowing anything.
Test:
I made several tests where I enable/disable mowing and I change the direction
1. (normal) rosservice call mower_service/mow_e…
-
Firmware 2.0.7.2
FAN0 always on from power up (part cooling fan)
Only started doing this today, for the past few weeks it’s been fine.
Now it doesn’t respond to gcode or the settings via the…
-
- [x] the power detector thresholds are free floating: DET_TRH_REV; DET_TRH_FWD; maybe add another MAX DAC
- [x] the JK flip flop RSTn and CLK are shorted together on top entity which don't make much…
-
1N5817 is solid for add-in USB-backpower protection diode purposes, but could be swapped /optioned with a lower forward voltage alternative if a SOD123 surface mount pad option was added. The surface…
-
I have 2 different kind generic controllers (made in china), one of them work perfect, but the other kind don't work with PSXNwelib.
I try withe library PS2X_lib and the control work, switch to PsxN…
-
Hello!
Thank you so much for all the hard work that has gone into your firmware, testing and documentation. I read that your goal is "_Make translational drift accessible to more combat robot build…