-
Is there a way to port this code to ESP-IDF to run RNode on a TTGO T-Beam or like ESP32 based LoRa device?
Cheers
Stephan
-
Great work so thank you for this. I intend using it to replace a dead v4 Milight bridge and with Hass.io
I have flashed 1.6.5 onto a NodeMCU V2 and have a NRF24L01 module (that was working with My …
-
ESP32-C3 is a cost-effective, RISC-V-based MCU with Wi-Fi and Bluetooth 5 (LE) connectivity for secure IoT applications. The ESP32-C3 is a chip recently released by Espressif
When I run the follow…
lybgo updated
2 years ago
-
Rather than just sending a string response to an http request I would like to send a file from an ESP32S2 board that I am running CircuitPython and ampule on. If it is possible to do this, can you te…
-
Hi Team, first of all thank you for your work on this.
I am wanting to use a Adafruit FT232H breakout via its SPI to communicate to an Arduino that is using the RF24 library.
FT232 inherently us…
-
The only residence of the wings for the present v1.0.x release are the servos. There is plenty of real estate for electronics in the outboard sections of the wings, at the risk of increasing rotationa…
-
>if you have a known channel that you like to use you are able to type in the callsign, center frequency and dial frequency...when you start the session, it proceeds but, sends you the message that it…
-
Team Anant is an undergraduate student satellite team of Birla Institute of Technology and Science, Pilani. Our objective is to design, build, and launch, a 3U nanosatellite with a hyperspectral camer…
-
Hi,
I would like to use your software to integrate a Bresser 9602510 (5in1) sensor via MQTT into my system.
I can't get it to work. I already stopped after "Starting execution..."
I followed your…
-
I want to set AX5243 in DBPSK 100bps at 868M on a 200KHz bandwidth and receive continuously, is it something possible with your implementation?
Also, is there a way to set the preamble (19bit in my c…