-
on Arduino NG whith atmega 8 this library doesn't working.
-
I was looking at the part where you bridged the 16-pin pad so that the 6-pin RS232 pad gave you Rx/Tx (nice!). However, which USART are they connected to? USART0 or 1? I would suspect USART0 but would…
-
As I have some experience with designing hardware and will want to make this as well, I think it might be worth it to throw ideas and discuss hw options in terms of simplifying the design and/or makin…
-
Should we have status LEDs that are always or periodically visible to indicate team ID or other effects such as invulnerability, quaddamage, dead, etc?
These would have an impact on power consumpti…
-
-
nRF24L01 2.4GHz Radio/Wireless Transceivers How-To
http://arduino-info.wikispaces.com/Nrf24L01-2.4GHz-HowTo
data sheet
http://yourduino.com/sunshop2/index.php?l=product_detail&p=188
-
```
thr cut and thr hold potentiometers scroll the menu up and down after I soldered the resistors and wires for tx and rx output. soldering is good, no bridges or so...
```
Original issue reported …
-
```
thr cut and thr hold potentiometers scroll the menu up and down after I soldered the resistors and wires for tx and rx output. soldering is good, no bridges or so...
```
Original issue reported …
-
Issue #1a:
This device's 3.3V(nom) MISO output doesn't meet Vih(min) when used with a 5V MCU. For example, when used with a 328p operating at 5V(nom), the 328p's Vih(min) is VCC*.6. This means Vih(…
-
```
thr cut and thr hold potentiometers scroll the menu up and down after I soldered the resistors and wires for tx and rx output. soldering is good, no bridges or so...
```
Original issue reported …