-
I have some 13" wheels that have a different motor configuration than that of the hoverboard motors. My motors have less stator arms/windings. Is it possible to alter the firmware to account for this…
-
```
BLDC control can be done totally on hardware by using logic gates which
actually requires more space for the pcb but may be more robust than the
software running to control phase excitations of ea…
-
Hi, I'm a complete noob. 👋🏻
I can't tell if any of the layouts are the one I have.
I was able to unlock the board and flash it from Keil but now I'm afraid to power it on due to not knowing whi…
-
# :wave: Welcome to GitHub Learning Lab's "Introduction to GitHub"
To get started, I’ll guide you through some important first steps in coding and collaborating on GitHub.
:point_down: _This arrow m…
-
Hi, I have a module that compiles to ram just fine, but it fails when compiling to flash with a stack underflow error, the code that fails is:
```
0 :noname \ loop time overhead of task is ~47…
-
Is there any way to configure complementary CHxN outputs and deadtime, like CH1 CH1N?
-
Hello,
I am designing own ESC using open source BLHeli Firmware. I have flashed (mystery 12A hex file) .hex file into ATmega8a (32 pin) microcontroller using USBASP and the program is successfull…
-
Hi,
I'm a new member of this wonderful forum. I would like you to help me find a solution to my problem, please!
So, my problem is that I purchased Hoverboard for robot projects. Unfortunately, I …
-
Redesign throttle to use DC Brushless Motor instead of Servo due to backfeed issues using a servo.
Slip drive may not be required.
-
The motor makes a mechanical sound at first and does not work.
I would appreciate any help in terms of hardware or software.
The Arduino code used is as follows
```#include
// software interrup…