-
Hello,
I get some errors when running the script, maybe my Nibe SHK200M is not supported.
This is from terminal window:
thomas@raspberrypi:~ $ nibe-mqtt -c /home/thomas/config.yaml
2023-05-2…
-
Moin,
ich habe seit ein paar Tagen das Problem, dass ich keine Werte mehr erhalten. Im Log nachgeschaut konnte ich sehen, dass es Probleme mit mit oauth gab ("error from /oauth/token").
Daraufhi…
teuti updated
5 months ago
-
Should be a restoreentity-sensor that survives reboots
On hitting limits it should make sure to heat water all the way to max temp.
-
### The problem
After upgrading my SMO S40 to 2.22.6 the entity (`sensor.current_be1_30051`) exposing the first (and only in my setup) toroidal current sensor went unavailable.
Searching through the…
-
Kaukora seems to have started to roll out the migration of heat pumps from their myUpway system to the new myUplink (which supposedly is more or less the same as Nibe's Uplink).
It would be good to…
-
Here it is written about connecting the power supply directly from the CTS602, where, among other things, +12V and GND are output.
> https://github.com/nic6911/ESP32_Modbus_Module/raw/main/electronic…
-
my apologies for the somewhat stupid question here.
but how to call the hot water boost function from an automation ?
(there seems to be no documentation here on how to use this integration)
…
-
### The problem
I cant install the myUplink integration installed. I have an app at dev.myuplik with ID and Client secret, when installing the integration it all seamingly run through until the las…
-
### System
- HAOS 11 (tested both public and private access, right now it's set to be public) - installed like 1 week ago fresh, didn't touch anything except allowing `trusted_proxies` in `configur…
-
After the last commit I can validate the config, but I am unable to install:
```
udp:
# The target address(s) to send data to. May also be multicast addresses.
target:
- ip: 192.…