-
From shelf temperature (room temperature is 26°) to SWISS display (powered from~1min) both show:
Black DOL-001 34° seems OK
Indigo DOL-001 54° Off by around 20° (if we consider the black as OK)
Sil…
-
# Achieving 11M IOPS & 66 GB/s IO on a Single ThreadRipper Workstation | Tanel Poder Consulting
TL;DR Modern disks are so fast that system performance bottleneck shifts to RAM access and CPU. With up…
-
Radxa sells an updated version of their [Penta SATA HAT](https://radxa.com/products/accessories/penta-sata-hat/) for $45, and it includes four SATA drive connectors, plus one edge connector for a 5th …
-
There is a spot on the 5M for screwing on a 40mm fan, if you remove the back, where it would pull air through the HEPA filter in the pro. I'm printing out the enclosure FF released a few days ago for …
-
The new Pi 5 has a D0 stepping, which supposedly has a smaller die (for better cost per chip) with some of the 'dark silicon' Broadcom used for other purposes removed.
Right now it seems to only be…
-
I've been able to confirm that the [24V NF-A4x10 on Amazon](https://www.amazon.com/dp/B0CN39MCPL) is a direct replacement for the stock fan, utilizing the included Molex -> JST-XH adapter cable, but i…
-
I've been trying to get a BLTouch setup with my Ender 3 and E3 Mini 1.2 board. But the firmware won't load and i get a TMC Connection Error.
What does this actual error mean?
I've tried compilin…
-
Hello Frank,
over the last weeks since I have a new PC built I did quite a lot of research how to get the temperature sensors to work. Just with the stock lm-sensors, nothing is really working.
…
-
Hi, thanks for your project, I will try to build it with a noctua fan for my fish tank.
BTW, I have a question : I am planning to use 12v power adapter for the fan and micro usb cable for the esp32.…
-
Hey! I saw that liquidctl supports the NZXT Z63 and Z73 coolers, which is great.
I have the Aorus Liquid Cooler, which is essentially the exact same hardware, screen, and pump design since it's mad…
zilpe updated
10 months ago