-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Transmitter firmware
### Current Behavior
I flashed to…
-
Hi,
I compiled the 0.14 version compiled in Arduino IDE got some error.
```
too few arguments to function 'uint16_t mavlink_msg_gps_raw_int_pack(uint8_t, uint8_t, mavlink_message_t*, uint64_t, …
-
Hi, I have connected a 100kNTC and resistor circuit to my RP2040 as per the diagram.
I have confirmed this is works in the GUI in debug mode, however when I discover new sensors on my Taranis it only…
-
I'm getting a lot of sensor lost warnings with ELRS (v3.3.0). I have the telemetry rate set to standard. I do see the sensors turning red at different intervals. So it looks like not all sensors are s…
-
rx-R9MM-f103rb-elrs-bl-v1.1.01-@19066cb.elrs
receiver outputs sbus instead of crsf.
mLRS.lua: Edit Rx: Out Mode is fixed to sbus (disabled).
-
Hello. I have problem with R9M Slim+ OTA. With ACCST firmware fport telemetry work fine. When i upgrade to access telemetry stop working. May be this is FW problem, may be no.
I check this receiver w…
-
Update the R9M as receiver section so that one doesn't need to rely on Discord or RCGroups.
-
No Frsky Sport Passthrough on external module bay X12S
the internal ISRM 2.4 works Great with frsky Passthrough
![access](https://user-images.githubusercontent.com/9161926/209418515-b867485b-9bd…
-
In enabling FLEX support as part of #1043, it was noticed that there is no "S.Port Link Enabled" shown at any time or RF Power option when FLEX selected.
![image](https://user-images.githubusercon…
-
Hi,
since R9M lite Pro TX Frsky external module needs st-link flashing,
but configurator 1.6.0 complains st-link not connected, (actually st-link >>IS CONNECTED