-
In v1.1.0 we need to increase the height of the lid (~2-3mm) as it collides with the relays on the double relay board, causes some flexing.
-
```
On a denkovi 8 relay board the state function doesn't work correctly
What steps will reproduce the problem?
1. power on one of the relay
2. send the state command
3. still says off, however re…
-
```
On a denkovi 8 relay board the state function doesn't work correctly
What steps will reproduce the problem?
1. power on one of the relay
2. send the state command
3. still says off, however re…
-
```
#import the pyserial module
import serial
import socket
import ncd_industrial_relay as ncd
#set up your serial port with the desire COM port and baudrate.
serial_port = serial.Serial(port='C…
-
### Board
[SparkFun Qwiic Single Relay](https://www.sparkfun.com/products/15093)
### Notes
* Existing [Driver](https://github.com/sparkfun/Qwiic_Relay_Py)
-
Finished the signal generator (PCB 1) today. The 200hz and 20khz range worked as they should and THD was very low too, about 0,0005 % which probably is as low as I can measure.
How ever the 2khz ra…
-
### Current Situation
I have been using a rPi running https://github.com/homebridge/homebridge-raspbian-image.
This rPi controls my garage door via the GPIO pins and a relay and detects if the door …
-
Hello, devices I've bought recently (2 relay version) all have the same ID=HURTM:
```
hidusb-relay-cmd.exe ENUM
Board ID=[HURTM] State: R1=OFF R2=OFF
Board ID=[HURTM] State: R1=OFF R2=OFF
```
…
-
Relay 2 does not turn off 9v pin on flight controller.
Assigned CH8 to relay 2. Verified relay 2 is associated to GPIO pin 81. Tried different relay default options with no change. iFlight …
-
```
What steps will reproduce the problem?
1.
2.
3.
What is the expected output? What do you see instead?
./drcontrol.py -d DAE0002Y -r 1 -c on (Open relay 2)
./drcontrol.py -d DAE0002Y -r 2 -c on …