-
I am trying to use the example code on a longan I2C CAN BUS module. I use a adafruit friend as FTDI.
When i run this code : (stripped to bare minimum)
```
#include
#include
#include
S…
-
Probably my fault, but the s3 feather with psram is not keeping the co2 data updated, seems like it's logging erroneously too, this is the bootup and I've never seen so many connected messages between…
-
Hey, I'm trying to use SCD41 + ESP32 with this library, however, I'm getting a CRC error using this piece of code:
```rust
use esp_idf_hal::delay;
use esp_idf_hal::i2c;
use esp_idf_hal::peripher…
-
Currently each board type defines a list of sensors it includes but there is no provision to submit extra values (such as sensors connected to the Qw/ST port) alongside these.
I propose adding an o…
-
The [Low Power Operation document](https://sensirion.com/media/documents/077BC86F/62BF01B9/CD_AN_SCD4x_Low_Power_Operation_D1.pdf) says:
> Power Cycled Single Shot Operation (SCD41 only)
But the…
-
Product ID: https://www.adafruit.com/product/5526
Notes:
- Stalled, Arduino-Pico core does not yet support Raspberry Pi Pico W
- New network implementation class required (edit: maybe not - they…
-
Hello, I've found a strange error and I'm not sure what the problem might be. I've been trying to use ESP32 + SCD41 with no luck. I tracked down the problem to this piece of code:
```rust
// sourc…
-
Fails to initialise component after selecting i2c address and sampling frequency.
Only Temp(c) and Humidity show up, when testing the SCD41 with the new firmware (Temp-Fahrenheit has been added) it s…
-
https://github.com/energietransitie/twutility-twomes-co2-bt-occupancy-monitor-firmware/blob/acb4f05a22577dac3884725a79bb9027aa2e30bd/src/scd41_task.cpp#L39
-
**Describe the bug**
micropy fails to generate stubs from a PicoW board running Pimoroni Micropython, when no other stubs exist.
**Expected Behavior**
Micropy generates stubs succ…