-
This isn't quite a bug report, nor is it a support request. However I just received a SKR MINI E3 V2.0 and would like to tweak the firmware, however there is no stock `firmware.bin` file, and no examp…
-
i just got a SKR mini e3 v1.2. It was working for a while... somewhat (had issues with sensorless homing endstop always on triggered state), but soon realized the board became completely unresponsive.…
ecksa updated
4 years ago
-
If I boot the SKR Mini E3, it boots fine (1.2), but when I turn off the system and then plug in the Raspeberry Pi using Octoprint via USB, I get a TMC Connection error. Now the odd thing is that the X…
-
Hi,
I have Ender 3. I installed SKR mini E3 V1.2. It works good. I flashed new firmware v2.0. I like it more than v1.2. But on v2 USB connection doesn't work. So I came back to 1.2. But then I realiz…
-
When attempting to compile current Marlin 2.0.9 for my Ender 3 Pro w/ SKR E3 Turbo mainboard to account for adding BTT 12864 screen, autobuild marlin in VSCode displays an error:
In file included fro…
-
### Description
Skr mini e3 v2 died after one print running octoklipper over UART. Octoklipper was running on a raspberry pi 0 w2 and was communicating and powered by the tft pins
### Steps …
-
### Description
Hello everyone. I just upgraded my ender 3 pro from v1.1.5 to skr mini e3 v2. I flashed my mainboard firmware with pre compiled bin file. Just tried to use pause/continue but it d…
-
### Description
The FAN0 and FAN1 ports on the SKR Mini E3 V1.2 (and probably also the other revisions) are swapped, compared to the Creality Melzi 1.1.4 board found on the Ender 3 and 5.
In othe…
-
He all
I can't get the MAPLE USB Drivers to install under Windows 10 - I am running Windows 10 Pro 64 bit and every time U try to install the drivers for MAPLE it displays "The Third-Party inf does…
-
bootloader upload firmware after each reset (power on) if firmware.bin present on card
**steps to reproduce**
1. Compile marlin with USB mass storage enabled
2. Write firmware.bin to stock 128Mb …