-
I'm sorry to use GitHub to reach out, but I couldn't find a way to message or email you directly. I own a Victron distributor business and have demo systems set up and can give you access to a Cerbo G…
-
Using 2 x JK-PB via RS485 (mode 2)
Using Victron Cerbo GX + 2xMultiplus II (in parallel)
```
[20:38:30][I][canbus:717]: send can_id: 0x377 [ASCII] Max temperature sensor ID : 102
[20:38:30][I][c…
-
Hello,
Is there any chance to add Heltec/Neey balancers over BLE ? As far as i know ESPhome already support those devices:
https://github.com/syssi/esphome-jk-bms/blob/main/components/heltec_balance…
-
### Describe the bug
I swapped out the batteries connected to my JKBMS (from 100Ah to 280Ah), but systems 15s. I changed the maximum charge/discharge capavilities, and the total Ah in the BMS direc…
-
Dear Team,
I am already using successfully two Victron SmartCharge controllers via VEdirect and I am wondering if also the SmartShunt is supported by this adapter?
Did anyone already try this?
…
-
Hi,
I tried actually for 3 days to get your code running. Actually in MQTT is coming the message: invalid header 0xFF.
Its also not working, when I remove the MQTT as its recommended.
Here is…
-
### Describe the problem
Hallo,
using 2 DIY Batteries in Parallel , connected via rs485 (tty0 and tty1) to victron cerbo.
Battery Agreggator
 mehrmals am Tag zu einem Überlauf.
Vermutlich tritt bei den meisten System dieses Problem nicht auf…
-
Does anyone know the CANBUS pin assignment of a Voltronic Axpert MAX or MPPSOLAR or identical/similar devices?
I want to connect the DIY controller to the Axpert MAX and the information I can find is…