-
- [Stlink/v2-onboard ] Programmer/board type: e.g Stlink/v1, Stlink/v2, Stlink/v2-onboard
- [ V2J27M15] Programmer firmware version: e.g STSW-LINK007 2.27.15
- [ OpenSUSE 13.2] Operating system: e.g L…
kv193 updated
4 years ago
-
(this may border on anal retentiveness...but just wanted to point it out as an FYI)
When using the 1.3.0 release on macOS downloaded from https://github.com/texane/stlink/releases/tag/1.3.0 the `IN…
-
I'm wondering why the STM32F1 version does need 128kb of flash. Most of the blue pill boards i own only have 64kb flash. Also most of the blue bill boards on ali**** have 64kb flash.
Is it possible…
-
Hi,
I got approximately one response for -a very long shot of runs-, so StLink CANT be used on OSX...
```
➜ stlink git:(master) ✗ ./st-info --descr
libusb_handle_events() timeout
[!] send_recv
^C
`…
-
### Description
I've recently been seeing drops in temperature during printing. My hotend temperature will be set at say 200 and will be being maintained at that +/- a few degrees. However from tim…
-
Whenever I am using Thonny 3.2.1 to upload a .py file to a Nucleo STM32F767 or a STM32F401 board I got an error message.
If I am using Micropython a Nucleo STM32L476 instead I don't have this probl…
-
(somewhat related to #115 ) Not sure if you deserve this, but maybe you are not running CI with the git memory.x ?
With memory.x from the git repository, which has
FLASH : ORIGIN = 0x08000000, L…
-
## 概要
現在開発中の[FIDO2認証器](https://github.com/diverta/onecard-fido/tree/master/nRF5_SDK_v15.3.0)について、ハードウェアの選択肢を広げるため、nRF52840アプリケーションを、mbed OSに段階的に移植します。
mbed OSに対し、USB HIDサービス経由で、FIDO2各種コマンドが実行できる…
-
This was raised over here: http://forum.micropython.org/viewtopic.php?p=7566#p7566
A very specific patch that addresses that particular issue (very narrowly) would be something like this (patching un…
-
When creating a new cmsis project using the wizard, both Next> and Finish are greyed out in the wizard making it unable to create any new project from the gui. Issue occured after switching to the 2.4…