-
**Describe the bug**
Some gpio lines doesn't fire interrupts
**To Reproduce**
Load the Zephyr button sample into a stm32mp157c_dk2.
Press the button and check the serial output for interrupt mes…
-
** Our build process comprises of 4-5 commands so trying to use config file and use it in command but getting error as "Invalid property specified in the configuration file. Ignoring it and proceeding…
-
The boot serial console can be accessed from Grove Port.C on the CoreMP135, via USB serial.
U-Boot logs are output from Port.C pin 1 (non TX-RX swap signal), while the Linux console is output from Po…
-
Build a version of BBN Marine OS for m5stack CoreMP135
CoreMP135 Is arm based computer 4GB RAM and with many interfaces two CAN bus for NMEA 2000,
RS 485 for NMEA 0183,
Uart for pypilot motor co…
-
### Describe the problem
I have the following setup: https://github.com/arduino/arduino-ide/pull/1132#pullrequestreview-1031068976
When I start the application I see the following errors logged:…
-
Hi, I can see here: https://github.com/SoMLabs/openst-cube-mx/blob/dunfell/VisionSOM-dsi-rvt70hsmnwc00-emmc/CA7/DeviceTree/VisionSOM-dsi-rvt70hsmnwc00-emmc/kernel/stm32mp157a-visionsom-dsi-rvt70hsmnwc…
Qbicz updated
6 months ago
-
On M5 CoreMP135, the "poweroff" command does not shutdown properly. After some time, a reboot occurs.
The "reboot" command works correctly.
There is no difference between buildroot and Debian, and t…
-
Since Marlin 2.0 will support many different MCU architectures beside the AVR, STM32 MCU support is also in the work. There is currently planning ongoing to have one HAL for all STM32 boards.
The f…
-
Really great work with this!
Currently i am tinkering with the STM32MP1 MPU's from ST:
https://www.st.com/en/microcontrollers-microprocessors/stm32mp1-series.html
Boot Sequence:
- https://ww…
-
Thanks for creating this! Seems to be really promising for our purposes. But still, i'm bit unsure how to use it properly, or rather how to create new board definition using meta-kiss as a reference.
…