-
I'm looking to use an SX1276 based LoRa module on my raspberry pi, but not the one you refer to in your package. Are you still supporting this git? Please reply so I'll know whether I can solicit yo…
-
1. Stratux version:
2. Stratux config:
SDR
- [ ] single
- [x] dual
GPS
- [x] yes
- [ ] no
type:
AHRS
- [x] yes
- [ ] no
po…
-
Hi,
I am using Arduino Mega + Adafruit RFM95 (SX1276). The code is working, but I do not know how to send data to The Things Network server, and view them.
This is the console output:
 that I've successfully tested this lib with an EByte E32-900M20S (https://www.ebyte.com/en/p…
-
Hi David ,
Maybe you can help me and address me to a solution.
I just got two Dragino Bee board : http://wiki.dragino.com/index.php?title=Lora_BEE
and I'm trying to use them with two RaspberriPI Ze…
-
I have recently soldered my SX1276 modules to my custom board which has U.FL connector with U.FL to SMA cable connected to it and SMA has 5dB antenna connected to it.
SX1276 is connected to ESP32 usi…
-
I can power on the board (via USB cable), connect to the hotspot and access the status monitoring page. However not fix is reported (number of satellites stays at 0), even after several minutes outsid…
-
Please change OLED_RST to 0 (unused). The original GPIO 16 is used for Flash_CS on the board and change L_RST to 23, as the SX1276 reset is connected to GPIO23. Board worked now with this board templa…
-
Hello,
I am using RPi and SX1276 (Hope RF95W) transceiver operating at 915 MHz. The packet forwarder only detects the first message and won't detect any consecutive message even after 30 minutes. …
-
Hi,
I am using SX1276 based radio from ACSIP. I am only getting upto 500m in open space even when I enabled PABOOST and increased the dB upto 20. Do you have any suggestions or specific parameter to …