-
Hello everybody,
At the moment I am having an issue regarding getting a stable 3D gps fix from my ADALM-Pluto and would appreciate some recommendations on how to get a more consistent fix. Just as…
-
One question
To use this lib to access LTE-M/NB-IoT using SARA-R4/SARA-N4 needs some special initialization before to have access to the network ?
Some different AT COMMAND that those used to LI…
-
Hi,
when I use this ublox driver to collect data from ublox EVK-M8T using the mini-USB port, I get the error as following
![error](https://user-images.githubusercontent.com/24927996/32602836-979873…
-
I think it would be useful to have some simple callbacks for cellular connections that respond to changes in signal strength, using straightforward categories like Good, Fair, Weak, and Poor. From wha…
-
FormationFlight Direct GNSS should support UBLOX protocol, not just NMEA.
-
In the source / app_config.h @ line 22
Wi-Fi module was defined AW AM457 instead of u-blox MAYA-W1 as below
/* @TEST_ANCHOR */
#define WIFI_IW416_BOARD_AW_AM457_USD
/* @END_TEST_ANCHOR */
It…
-
**IF YOU DON'T REMOVE THESE FOUR LINES, THEN YOUR REPORT WILL BE CLOSED AUTOMATICALLY**
Questions and user problems should be directed at the forum (http://discuss.ardupilot.org)
ublox GPS reports…
-
Arduino Nano 33 IoT (Arm® Cortex®-M0 32-bit SAMD21) support requested due to identical issues with Nano 33 BLE while using the onboard WiFi/BLE (u-blox NINA-W10) -> interrupt issues with standard meth…
-
Hello,
sometimes I get an error, if I want to connect the rover with my Rasperry Pi. The base and the rover are connected to difference Raspberry Pi. I can start the base without an error. But if I s…
-
I'm trying to obtain a Rinex broadcast ephemeris file to use instead of downloaded brdc.
I record RAWX messages from u-Center (connected to a U-blox MT8 receiver) for one hour.
Then I use RTKCONV …