-
- [x] Test firmware compilation, many boards/architectures
- [x] Test example compilation, many boards/architectures
Try LED and accelstepper:
- [ ] run on uno,mega
- [x] run on m0/m4
Finis…
-
One thing that I often run into while testing more exotic setups is hard crashes (where the entire system needs a power cycle to get booted up again).
On the CM4 IO board, I typically short pins 12…
-
Hi,
I wonder if this library "usitwislave" can be used on ATmega328p (arduino uno) or at least is there a chance to make it run on ATmega if I adapt the registers to my device ?
-
The inverter has an averaging filter that is causing its output to be delayed.
-
Добрый день!
Возможно предусмотреть на новой ревизии платы место под установку компонентов для подключения датчика протечки к пину RESET?
Например вот так:
![image](https://user-images.githubus…
-
Hello, do I need to use a LIN transceiver (for example this one http://www.atmel.com/images/atmel-4916-lin-networking-ata6662c_datasheet.pdf ) with your library? I want to generate LIN 2.0 master fra…
-
Is it possible to let the monitor2.json output also go through the serial connection?
Maybe with a checkbox enable/disable in the GUI.
Then it will be (for example) possible to read this from a de…
-
The serial ports at the bottom of a TX16s use the lines uninverted. This make it easier for some DIY gear to be connected but requires using an SBus inverter if one wants to connect a receiver with "n…
-
### Description
hand held extruder- like a 3d pen, but less portable. i already have a mockup from a bolt/pc heatsink, and im working on modeling a handle to hold an e3dV6 or similar, but as marlin…
-
Hi Stuart
First I want to thank you for this excellent project, and it's amazing to see how specially the controller UI has evolved over time
I really like the 4.4 version of the cell modules, bec…