-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
```
What steps will reproduce the problem?
1. The noise on the video feed goes away when i touch the chips!
2. Tried enabling telemtery in the APM Mission Planner but it doesnt solve the
problem.
3.
…
-
If I set `SYS_USE_IO` to `0` on a Pixhawk 6X, I no longer receive RC.
```
nsh> rc_input status
INFO [rc_input] Max update rate: 250 Hz
INFO [rc_input] UART device: /dev/ttyS5
INFO [rc_input]…
-
I'm one of the NXP HoverGames participants and @igalloway asked me to open this bug report here in order to get support and make other HoverGames participants aware that we have an issue integrating t…
-
When I open simulation projects, especially in FMU settings, that has used pyscal to generate saturation table the Pc-curves is often quite unrealistic. and contains large entry pressures. This seem…
-
From time to time Coral seems to hang between instantiate and initialize. There are no changes done to the simulation setup but from time to time, and roughly 1 in 10 simulations seems to hang on `Par…