-
It would be really handy if `linear_extrude` could pass a parameter to the 2D block so that the cross-section could be different throughout the extrusion, for example:
```
linear_extrude( height= 7 )…
-
I printed an object with a single wall that is thinner than the extrusion width. Version 0.9.8 is vastly improved, as you will see in the photos. However, both versions failed to connect the thin wall…
-
I tried printing a wall single wall calibration part with current git head, but regardless of my "detect thin walls" choice, the part wasn't printed as a single wall. Should I use the spiral vase sett…
-
It would be great if a near-future release of Cura would render small holes (especially vertical holes) properly as small holes.
With Cura RC4, everything under 2mm is completely lost (smeared in), an…
-
-
![bildschirmfoto 2013-09-12 um 07 49 33](https://f.cloud.github.com/assets/3014437/1128600/220e7022-1b6f-11e3-8723-744352668a95.png)
```
Unable to cast object of type 'Container' to type 'List'.
a…
-
Date 29/09/2012
Configuration;
Prusa Mendel
Parcan Hotend
5x 42BYGHW811 Stepper Motors
Mechanical Endstops (sorry Makerbot V1.2)
Mk2 Heatbed
Sanguinololu 1.3b (Fan Cooled, 12v off ATX PSU, 5V off USB…
-
This has been quite a source of angst for me lately. When working with a loop of planar curves, the Loft Form node always fails to create single surfaces in the massing environment. I've used quite …
-
# Summary
After moving my laptop from Ubuntu 12.10 32bit to Ubuntu 13.04 64bit, I am suffering pronterface lockups while printing after a little under an hour of printing. The printer will stop in pl…
-
Minimal example:
```
module up(){
translate([0,0,1]) child();
}
up() up() cylinder();
```
This fails to generate the correct geometry with:
WARNING: Ignoring recursive module instantiation of '…