-
I keep observing feed in into the grid, even though my battery isn't full.
The battery is at 72% and yet the inverter is set to ~800W with only a ~330W demand.
The battery receives ~350W-ish.
Almos…
-
Add an on alarm on BOL frame timeouts and VE.Bus BMS frame timeouts.
See https://www.victronenergy.com/live/mppt-error-codes#err_67_-_bms_connection_lost
Multi firmware >= 502 supports a BOL fram…
-
Hi,
I tried flashing different versions with ESP32 flash download tool. Flashing process was ok but then there was no web interface on ESP32.
So I used PlatformIO and built from source. In this wa…
-
Just switching from the original ginlong-scraper to this one as the ginlong site isn't working for my anymore since the end of May.
I'm now sending output to PVO and notice that the Voltage is not …
-
Following fields available to report, the current Solar Input Watts and Total Yield Watts today
"model_name": "SmartSolar MPPT 75|15",
"solar_power": 0,
"yield_today": 20
-
Dear Elektra,
as I heard about your plans to co-use the ESP32 not only for controlling the MPPT charger, but also as an IP router, I initially doubted if this would work reliably.
However, I jus…
-
Hello , unfortunately "aggregate-batteries" doesn't work for me. At the moment I only have a DIY battery that is integrated with “dbus-serial-battery” and works. After installing “aggregate-batteries”…
-
![Screenshot_2023-08-30-15-27-44-461_io homeassistant companion android](https://github.com/slipx06/sunsynk-power-flow-card/assets/63303107/5405834c-117c-4cdb-9661-fc845264b44c)
### Is there an exi…
-
Hi,
I'm not sure if this is universal now after updating ESPHome, but in case it helps someone...On trying to install the code via ESPHome from the sample code for a Victron (100/30) MPPT controller …
-
Hello Stuart, i have a question about the balancing.
My 6s6p pack will charge within a voltage range of 10-20 mv between cells, but after the 4.1 threshold the pack is instantly debalanced some cells…