-
Hi, I am using an attiny85 as remote and a nodemcu as a receiver and flashed the example sketches on both and I have corrected the pin numbers.
Only the problem is, this works:
![0a0e5400-1b16-42a…
Tvde1 updated
4 years ago
-
#### Hardware
Hardware: NodeMCU & ESP8266 12F
### Description
I have 2 Access Points with same ssid.
My ESP8266 connects to the first of them, does some tasks and then modem sleeps (to save ba…
-
> Have you searched for existing (open and closed) issues describing the same problem?
Yes
**Describe the error**
It seems that the non existing settings can not be accessed and the hash can no…
-
Hi all, as the subject says I have been having issues connecting with the MQTT broker, even using the most basic sketch, what happens is that nodemcu will connect to WIFI just fine but then will strug…
-
Program Example8_SPO2 compiled successfully and got uploaded to Wemos D1 Mini.
Board I'm using MAX30102. Wire connection is as below:
WeMos D1 -> MAX30102
5V Vin
G Gnd
D1 …
-
### Describe the problem
Hi, currently I'm interested in getting arduino-cli package to the Alpine Linux repositories (I know that musl can be of issue here - that's why I add gcompat to the dependen…
-
I admit that I am not familiar with MQTT and Home Assistant and I need some help:
In the following code:
...
const char* mqttServer = "192.168.1.200"; _**The domain or IP where the MQTT is insta…
-
I use a E282G4M27S from Ebyte (without TCXO ... it's a pitty) and the output power is always the same (22dBm) regardless the output power selection.
73
F5MDY updated
2 years ago
-
hello all, i just collect data when node send to gateway(esp12e) via mqtt parsing so its great i also send downlink via mqtt over ttn network and i can follow traffic on application data
but when…
-
Hi,
I've just setup 1 of these nodes to test as I want to have motion detection for some of the rooms in my house to control the lights with Home Assistant, however I'm experiencing a constant rebo…