-
Hi,
I'm interested in working with the ubxlib for a future project, but have limited experience with embedded programming.
The project is based on an Arduino board, and looking through the library…
-
Hello,
Thanks for the great project! This has been very cool to play with and I really appreciate everyone's hard work!
### Step 1: Describe your environment
I'm using arm-none-eabi-gdb with P…
-
Hi,
I have been trying to install titan extruder, which needs recompiling firmware.
I followed exact instruction on readme, and got compile error.
Below is the error messages I got.
Tried both S…
-
**Problem**
Currently it is impossible to mark a pack device or board specific, except when it contains a `` or `` element.
**Suggested Solution**
Extend element [\](https://open-cmsis-pack.githu…
-
hello Everybody
I have a MKS Robin V2.3 board and Robin TFT V1.1R(with R61505U controller). I wanted to install Marlin-bugfix-2.0.x on it. but unfortunately R61505U-based TFT display is not supported…
-
Task is to integrate theCore with [KE02 MCUs](http://www.nxp.com/products/microcontrollers-and-processors/arm-processors/kinetis-cortex-m-mcus/e-series-5v-robust-m0-plus-m4/kinetis-ke02-20-mhz-entry-l…
-
Environment: STM32F76xx with micro sd card, nanoclr 1.3.0.3.
(Note: this issue is seen on microsd file, I did not test it on flash)
Repro steps:
- On the micro sd card, create a simple file with a …
-
Hello 正在复刻的朋友们,分享一点简单的经验。
1)舵机第一次调试时,会默认初始化本地I2C地址为12,并且在收到主控的Enable信号前不会有动作。
2】舵机第一次连接主控时,【需要一个个配置地址】,一次只连一个,在主控用0X00地址发送 SetId指令。 比如:头部舵机配置为0X02,断电重启,用主控测试能否用0X02连接到舵机。 然后再插第二个舵机。one by one.
3)…
-
I have this dev board and I am wondering if it would be possible to compile the mmdvm firmware on this:
https://www.st.com/en/evaluation-tools/nucleo-f722ze.html
Thanks for the very large help y…
-
I did some testing with fldigi, and wsjtx both on latest firmware from yesterday. This issue may be present or not in earlier firmwares.
Issue is that when producing a tone to tune from a PC over t…
Jmelz updated
6 years ago