-
I'm trying to control a frequenty controller (Optidrive E3) with my Arduino Uno. This Optidrive supports the modbus RTU protocol and so does my Arduino Uno (1.8.1 IDE) when using a MAX485 breakout bo…
-
During installation of BSplayer Pro 1.22 Build 817 in Windows 95, such error appears:
When installed…
-
The following runtime test failed on CI lane `Mono llvmaot Pri0 Runtime Tests Run Linux arm64 release` of PR #48397:
- JIT/Regression/CLR-x86-JIT/V1.1-M1-Beta1/b143840/b143840/b143840.sh. [Link](http…
-
Hi,
I'm running a simple test, two ESP32 connected with one cable (GPIO 25 GPIO 25), GND and 5V are also connected directly.
Linux crash logs are not added to test output or available in Jenkins test artifacts. The user is …
-
Having decoded the Pacific TPMS sensors as used by Toyota (at 314.98MHz) the total number of bits are 66 with a CRC8 calculated over the first 58 bits. The protocol matches the 9910bps FSK modulation …
-
**Describe the bug**
For some old files that may contains error as described in the title, this package fail to work and runs the process forever (dead loop).
**Related issue**
**To Reprodu…
-
I've tried:
- Running Monero on 2 NixOS devices (x86_64, 1 device in the fs and aarch64, 3 devices in the fs) with 6.7-rc2 and bcachefs (zstd compression)
- Running a libvirtd Windows VM on the x8…
-
Not an issue, is a request only if possible.
can you compile the project to be compatible with 32 bit architecture?
Decompressor works flawless with Majora's Mask!!!
Thank you for this tool.
-
Start QGC and connect px4 board by wire. In nsh console type `mavlink status`: rx loss percentage will be not zero (in different scenarios it could achieved 95%+), while everything is working normal.
…