-
Ciao a tutti è ormai da giorni che provo a configurare Marlin v2.0.7.2 con mainboard SKR 1.4 turbo
ho problemi sempre con le stesse cose
i motori sono TMC2208
questo è quello che mi spunta
PS C…
-
Hi I open this thread because the endstop on my printer are not working, they are well connected but they arent relevate, so the steppers doesnt halt when they touch any endstop.. so I cannot do any h…
-
### Description
### Steps to Reproduce
1. Tried Marlin (stable)/Marlin(bug fix) on MKS Gen1.4 with TMC2208
2. CoreXY system
3. Moving X and Y axes in any direction.
Expected beh…
-
### Version
2.2.53.1
### Operating system type + version
NixOS
### 3D printer brand / version + firmware version (if known)
TronXY X5SA with Klipper
### Behavior
I enabled 'Wipe while ret…
-
### Description
I recently changed only one of my stepper drivers on the X axis (TMC2208) from legacy mode over to run on UART to test it out. When I did that the stepper now makes a loud grindi…
-
### Bug Description
The extruder randomly stops during prints.
### My Configurations
[Marlin Bugfix-2.0.x Config.zip](https://github.com/MarlinFirmware/Marlin/files/4606041/Marlin.Bugfix-2.0.…
-
Bart, Thanks for keeping up the great work!
I have some experience with Grbl_Esp32 running on MPCNC_V1P2 and am curious to test drive the new WebUI and 6-pack controller.
Currently I don't have …
-
I am replacing my factory main board with a V2.2.1 board (https://smile.amazon.com/gp/product/B085DM75Q6/ref=ox_sc_act_title_1?smid=A3SNVVMEXOSKIB&psc=1)
Have you heard of any issues running the cu…
-
Good evening, I installed the MEGA_S_TMC_BLT_10_v1.1.6.hex release, I connected the printer to the raspberry with octoprint on raspbian, I started a print and I noticed that the axes were jerking. How…
-
Running Marlin 2.0.7.2 on SGEN_L V2.0 with 12864 LCD and MKS TFT35.
Used to be able to compile and upload firmware from my PC to the SD card in motherboard's reader via USB. After moving to this m…