-
**Tell us about your setup:**
1. What iDevice are you using? Iphone8
2. On what version of iOS is it? 13.3
3. What version of checkra1n are you using? 0.10.1
4. What is your host system (OS versio…
-
Dear Sir Ryzee119
your project Tinyogx360 seems very interested
i'm really want to try to build it , every thing seems good in the project file (BOM, PCB GERBER, FW)
but just only thing for block…
-
Currently running Klipper on Ender 3 V3 SE. Recently updated, and needed to update the Exapnder board. When I try to update it, I get the following error:
biqu@BTT-CB1:~/klipper$ make clean
biqu@B…
-
Hi,
I am trying to design a board based on BlueMicro using this schematic:
[http://nrf52.jpconstantineau.com/assets/images/schematic_bluemicro840_1.0-a8bab4054d9ddeeb92fb4297b6b22eda.png](url)
Wh…
-
```
What steps will reproduce the problem?
1. After have issue53 i want to uninstall
2. Bootsplash: There is just: iPhone - Install - Froyo
3. If i hold the Home Button at "iPhone" the 3.1.2 just boot…
-
```
What steps will reproduce the problem?
1. After have issue53 i want to uninstall
2. Bootsplash: There is just: iPhone - Install - Froyo
3. If i hold the Home Button at "iPhone" the 3.1.2 just boot…
-
Serial bus is currently a 2 wire Tx/Rx. In the do do list bucket, please add support for RTS/CTS hardware flow control.
-
Hi, i used katapult on multiples MCU and work great, but i tried on stm32f042 this contains 32kb flash. I tried to compile katapult using application start offset 4k but final binary is more large tha…
-
Hello, I'm using the USB_USB converter bought from you; I've tried almost all the usb keycodes described in the firmware, by assigning them to virtual layers. The testing method has proven quite unrel…
-
I've flashed hid_generic_pc13.bin with stm32cube programmer
When plugging in the USB with a known good cable the LED blinks quickly, I have 4 bluepills, all exhibit the same behaviour.
I don't have …