-
- [x] Determine what the stackup height is. @biomurph is planning to solder the Teensy to the Tympan
- [x] How do users access the SD slot?
_Here is the existing enclosure for the Rev-E with AI…
-
I am getting repeated errors from the plugin:
Firmwareversion is 3.5.7_002008 undefined
Plugin version 0.14.1
[11/20/2020, 12:44:55 PM] [Rosie] INF getDocked | roborock.vacuum.s5 | Robot Docke…
-
Hello all,
I am not sure how I caused it but right now the deebotEcovacs plugin always makes my Homebridge crash. I uninstalled and removed the config and accessories, upgraded all (nodes, home bri…
-
***
### Daily status - 2021 October
This is the daily status thread for 2021 October. Daily status posts will be put daily (or when I get to it) below this post.
[Click here to see last m…
-
The master branch seems not to be in a working state.
I'm using the current 'master' branch and the 'behavior_tree_executor' branch of the 'example' depot.
In a first terminal :
```
ros2 laun…
-
## The problem
Until about HA 116.x the neato integration was working correctly: service calls were triggering the robot correctly.
Now triggering the same service call yields only an issue sound …
-
- [x] The font is a little rough. Would prefer a cleaner font over the buttons.
- [x] I like that it needs power/charging.
- [ ] Would prefer an LV recipe. I am ok with it needing the Mv-grade circ…
-
***
### Daily status - 2021 November
This is the daily status thread for 2021 October. Daily status posts will be put daily (or when I get to it) below this post.
[Click here to see last …
-
Hallo,
ich habe einen "DEEBOT OZMO 950 Series", die Steuerung funktionen ohne Probleme. Es wird seit ein paar Tagen allerdings die "spotAreaName" nicht mehr ausgefüllt bzw. wenn ich den Adapter lösc…
-
I just found my robot roaming around in the middle of the night on a mission to find its base because there was a power outage and it went into the idle state. It was already docked, but since the doc…