-
Hi!
My application uses web socket authentication when connecting with the Central System, I imagine this is a common security measure in EV chargers.
I was thinking about making a pull request to …
-
### The problem
Tesla wall connector was providing connected/disconnector sensor without issues until I upgraded to 2023.5, sensor shows up as unavailable, integration reports "Failed to set up" with…
-
Hello,
after some time the API status shows "Error" and no data update will be done.
If i reload the integration it works fine again.
On the next occurance i will activate debug log and then …
-
### Describe the bug
Nach dem Wechsel von Version 1.119.5 nach 1.1120.0 produziert eine Wallbox mit dem phoenix-ev-eth controller und der firmware 1.27 folgende Fehler:
vcc[1008602]: [lp-1 ] ERRO…
-
Hi, I have set up the CP line for EV mode for the White beet PS 1.1 but when I connect it to a charger, I am reading that the CP line voltage is negative (or in state F).
It seems like similar issu…
-
Hi
I am using Rasberry Pi as Client. Here i want to send the Power Consumed by the vehicle and send it to CSMS.
Can anyone please tell me how to measure those values and send it to CSMS and i am ne…
-
I have been using the integration since the first release, and almost all of the issues have been solved during the rapid releases :)
My installation throws the error: "Failed to update sensor asyn…
-
## Is your feature request related to a problem? Please describe.
## Describe the solution you'd like
It would be useful to be able to change between Reduced and Maximum Charging current, …
-
We had this exception in the logging. Not sure what went wrong exactly but the EV charger seems to accept the charing session, then immediatly (about 450ms later) stopped the transaction and while sto…
-
Please see below the expected fields of a typical payload describing a charging station
``` JSON
{
"IsRecentlyVerified": boolean,
"DateLastVerified": date,
"ID": long int,
"UUI…