-
I've tried to compile a custom version for my NAZE target without Serial RX enabled since I don't use it.
In target/common.h I can compile if:
#define USE_RX_PWM
#define USE_RX_PPM
//#define SER…
-
As my title suggest, there is no means to adjust the endstops for these added channels. I see youve put in additonal items in the extra menu. Is there room there for endstop adjustments? Also, i seem…
-
request for ibus telemetry support and/or transfer of code from https://github.com/unitware/cleanflight/tree/ibus-telemetry to betaflight 3.xx
original issue from cleanflight https://github.com/clean…
-
Hi guys, my pos hold issue continues. When I switch on nav poshold, it rounds around holding position for one time and holds in the air at the right position.
My SP Racing F3 and ublox m8n gps use…
-
Hi,
I'm using a FlySky i6 Transmitter with custom firmware which allows me to put the RSSI on an AUX channel.
However the scale of this RSSI is:
0% error = 2000
10% error = 1900
20% = 1800…
-
Set:
- Transmitter FlySky FS-I6;
- Receiver FS-A8S;
- F3 V4 AIO flight controller;
I have flashed BetaFlight 3.1.6 (SPRACINGF3, default parameters), configured receiver via I-BUS protocol.
Steps …
-
I am running a Taranis X7 with OpenTx 2.2.0N365 and the Banggood 4 in 1 module with V.1.1.6.20.
Range test mode works with all protocols I have tried (including Flysky standard), except the FlySky AF…
-
Hello.
Channel 6 is set at VRB in the helicopter variable pitch type, and the correct position is the throttle rocker.
Why not support IA6 and support only IA6B?
Can you modify it? Where can I fi…
-
Hi there
I have updated on the latest cleanflight version 2.x.
I wasn`t happy with this version so I flashed the older version on my Naze32 and the older version on my laptop. Since then I have no…
ghost updated
7 years ago
-
Hi,
I wanted to test out TBS SmartAudio so i got a TBS UNIFY PRO 5G8 HV - RACE. I'm using an Omnibus F4 V2 FC with the OMNIBUSF4SD target. Reciever is a Flysky X6B (using IBUS) connected to UART1.…