-
I like the brevity of your project. I would favor it over [this other](https://github.com/ArmlessJohn404/RPistepper) However, your [PyPi project](https://pypi.python.org/pypi/pigpio-stepper-motor/0.8)…
-
I'm sorry for my bad title but I couldn't think of a better one.
I am using StepperOnline DM860T drivers connected to a GRBL controller.
Previously I used cheap TB6600 drivers which worked instant…
-
Hey, Can anyone confirm if the motor gets HOT if the NodeMCU/ESP8266 is not connected?
I am starting this amazing build and during voltage checks I notice that the motor gets very hot when the node…
-
Hi, first of all sorry, i usually code in python, this is a little new to me.
I have the issue that i want to drive a stepper with a rather high speed (200RPM) and change the speed acording to an Ana…
-
Hi ,
is it possible to use this script with an application in 3D scanner mode 360 on the Z axis and using a brusless GM6020 like the livox opensource project? What do you think?
regards,
fab
-
I was configuring my printer and everything was going well. The hotend was heating up and the motors were moving correctly. All thermal protections were enabled on the configuration.h.
At one point…
-
I set up the firmware and started playing around with the controller.
Motion seems fine but the spindle speed seems to be binary on/off rather than continuous.
I can't seem to be able to control…
-
I have my pins set up as
pin 11 to 12
pin 18 to pin 3 on the arduino
pin 20 to pin 2 on the arduino
and pin 19 to ground.
the floppy drive is being powered by the Arduino on 5v line
I tried the …
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
As soon as I boot the BTT SKR3 EZ board I get a TMC Connection Error reading ALL HIGH on all axis regardless of the number of drivers installed.
I cannot move any of the steppers while this error is …