-
Currently (as of 2.7.4) the only way to change rtapi's logging message level is to change the source code and recompile. It would be better if it was easier, perhaps through the [EMC]DEBUG setting in…
-
I'm putting together a system with a handful of Beckhoff modules that I'm going to use for testing. The goal is to have code changes verified against at least *some* of the modules that we support. …
-
Currently testing a few EL3xxx and noticed wrong value calculated in the EL30x4 vs EL31x2 driver.
Typo in the 30x4.c driver:
// update value
value = EC_READ_S16(&pd[chan->val_pdo_os]);…
-
I'm trying my first steps with LinuxCNC and EtherCAT. Following the example of [this forum thread](https://forum.linuxcnc.org/24-hal-components/42291-basic-ethercat-configuration) I started with:
`…
-
Do you have the LCD printing out the correct information? I can't get mine to work.
I don't have a Duet but rather am running FluidNC on a TinyBee. I forked your repository at [GRBL-USB-CNC-Pendan]…
-
I have searched a lot over the internet but could not figure out the G-code syntax for touch off and saving that tool height in non-volatile memory just like work offsets. What are all queries related…
-
The website can be really hard to read. It is clearly not
ADA compliant.
Take this page for example:
https://www.linuxcnc.org/documents/
The text at the bottom is small, and light gray font…
-
### Discussed in https://github.com/Peter-van-Tol/LiteX-CNC/discussions/62
Originally posted by **Peter-van-Tol** December 10, 2023
There are some upcoming changes in the watchdog, for safety …
-
Hello, it seems there’s a typo in the names_misc_errors array definitions inside of motion.c.
It appears it’s using the count of array elements of names_dout instead of names_misc_errors, which …
-
Right now, adding new drivers involves a few steps:
- Writing the driver itself, in lcec_xxxx.[ch]
- Adding the new driver to lcec_conf.[ch]
- Adding the new driver to lcec_main.c
- Adding the new…