-
Hello Sandeep
I added these Serial.println for debugging in the Library:
{
Serial.println("LoRaClass::endPacket: before writeRegister(REG_OP_MODE, MODE_LONG_RANGE_MODE | MODE_TX);");
// put …
-
The default installation did not work so I added symlink:
```
ln -s /usr/local/lib/python2.7/site-packages/lora ~/.local/lib/python2.7/site-packages/lora
```
but still I get an error:
```
Traceb…
-
Hello,
I am using examples from this LoRa library. When I used code LoRaSender then it is working fine and sends data. But to receive the message when I used LoRaReceiver code then, it is not at a…
-
Hi there,
firstly, many thanks for this lib.
I would like to build small network of slave devices based on arduino boards and one master (gateway) device based on esp8266 casting as gateway for ot…
-
Hi,
I tried connecting two rfm95 modules to arduino mega.
I have used the same SPI pins but different SS, RST and interrupt pins.
I defined a new Lora class and set the new SPI pins using the n…
-
Since 1.10.0.b1 I having issues with receiving data through raw LoRa non-blocking socket within a while loop. In case the loop is interrupted the data can be received by socket.recv() entered through …
-
Does this library support this board ?
If yes , how do I set pin or use it .
I try to use the LoraSender and Lora Receiver in Example for transmit data between 2 boards but I got the message "St…
-
Hi,
possible change software (add #define ... to library.cfg for example) so i can use GPIO mode 2 and GPIO0 as "rx_buffer_not_empty" on PIN7 to implement interrupt mode on RPi ?
Thanks in advance…
-
It's will be good to add +20 dBm mode for SX1276 board and written in manual http://www.semtech.com/images/datasheet/sx1276.pdf
```
see 5.4.3. High Power +20 dBm Operation
```
I have 2 boards: htt…
-
How to receive manual? (with AT+Commands ? )