-
### The problem
I think I may have found a bug, though I am not sure - that's why I am here ;)
Situation:
- using modbus
- using a script to write a value to a specific modbus register
us…
-
Tested on Linux. I have a embedded application where I have a separate thread with sync Read/Write operations in loop and after migrating from mono, this thread CPU usage went from 5% to 25%.
Typi…
-
We have just had a new solar array installed and attached to a Solaredge SE 11400A inverter. Like many before me I found out that to get the data from the system I would have to go through the solare…
-
**Describe the problem you have/What new integration you would like**
I have some max485 that I use to create dmx device for my light dmx is cool because its a bus system and require only 1 esp t…
-
I'm wondering whether it would be possible to add the KNX-IP protocoll to ESPEasy. There is already a good basis [here](https://github.com/envy/esp-knx-ip).
This would provide the ESPEasy possibiliti…
-
Hi @syssi
I am using your jk-bms components for quite sometimes and I discovered the following (may be related, I am not quite sure)
My setting was:
esp32S2Lolin mini
uart on Gpio9 and Gpio10
I …
-
### Is your feature request related to a problem?
Please can you add the possibility to add own interrupt handling function with uart_isr_register to version 5.like in versions 4, because otherwise w…
-
Hi, in regards to
https://github.com/syssi/esphome-jk-bms/pull/409
and
https://github.com/syssi/esphome-jk-bms/issues/390
it seems to be (also) about converting a RS485 signal to read data fro…
-
Hi,
I have been trying without success to get either of a pair of DingTian 4 relay units (one is RS485 + Ethernet while the other is CAN + Ethernet) to work over Ethernet (also tried the RS485 inte…
-
Hey I happen to have more specs for the TTL UART protocol for this device, but I'm currently trying to figure out how to tap into the unit (USB, internal pins? my strengths are software). Are you inte…